DC 12-24V Car Refrigeration Air Compressor Fridge Freezer Marine Solar with Temperature Controller,Working volume:2.5cm³,2000-3500RPM,BD25HC

Compressor parameters:Compressor model: BD25HRated voltage frequency: 12-24V (DC)Working Back Pressure: L.B.PCooling status: natural cooling / air-cooledThrottling device: capillary tubeMotor type: BLDCAmbient temperature : 0～43℃Evaporating temperature :-35～-10℃Operating voltage range :9.6～17/21.3～31.5VMax. exhaust pressure :1.86 MPa(abs)Minimum case pressure: 35 barOil type: Ester oilOil filling volume :150ml±10mlDiameter of suction pipe (inner diameter) : Φ6.2±0.1 mmExhaust pipe diameter (inner diameter) : Φ5.0±0.1 mmProcess pipe diameter (inner diameter): Φ6.2±0.1 mmCompressor noise :≤40dB(A)Vibration :0.6m/s²Working volume:2.5cm³Cooling Capacity:RPM is 2000, cooling capacity is 45W , 38.7 Kcal/h ,153.5 btu/h,Efficiency COP is 1.25 w/w,electric current is 2.9/1.4，input Power is 36WRPM is 2500, cooling capacity is 55W , 47.3 Kcal/h ,187.7 btu/h,Efficiency COP is 1.25 w/w,electric current is 3.5/1.7,input Power is 44WRPM is 3000, cooling capacity is 64W , 55 Kcal/h ,218.4 btu/h,Efficiency COP is 1.25 w/w,electric current is 4.1/2.0, input Power is 51W RPM is 3500, cooling capacity is 74W , 63.6 Kcal/h ,252.5 btu/h,Efficiency COP is 1.25 w/w,electric current is 4.9/2.4, input Power is 59WDigital Thermostat Parameters:Voltage range: DC 12-24V, limit 35VOperating current: 0.1ADoor Lamp Function: Door lamp voltage follows input voltageTemperature probe accuracy: ±1℃Operating ambient temperature: -10℃～60℃, relative humidity 20%～90%Package Including1 x Compressor1×Temperature controller

• Installation: Insert the three-phase output plug of the controller tightly into the terminal of the compressor, and tighten the screws after the controller is set into the mounting card of the compressor
• The controller automatically adapts to dual voltage, i.e. DC 12V and 24V power input systems; The maximum input voltage is 17V for DC 12V systems and 31.5V for 24V systems
• External Fan: A 12V DC fan can be connected between the terminals (F+) and (F-) of the controller, the positive terminal of the fan is connected to the (F+) terminal of the controller and the negative terminal is connected to the (F-) terminal of the controller; The output between terminals (F+) and (F-) will always remain at 12V when the input voltage to the controller exceeds 12V; The fan must be a 12V DC fan regardless of whether the input voltage system is 12V or 24V
• The operating temperature of the controller is not greater than 50°C; when the temperature of the controller case is too high, the compressor will be stopped and over-temperature protection will be generated
• Temperature switch: The temperature switch is connected to the C and T terminals of the controller; If no resistor is connected in between, the compressor will run at 2000rpm when the temperature switch is closed